Dispersion Box 10 PS IDC PT

 Dispersion Box 10 PS IDC PT

The housing consists of a base and a cover gray or black, for the 10 made ??of polyethylene and PS.
Multipair cable connection is via a pressure tool that runs it without removing the jacket.
The double-tab terminal strip is made of thermoplastic PBT reinforced with fiberglass.
Dial has numbered tabs 1-5/6 – 10, allowing clear identification of the couple.
Yarnfingers packaging material has soft PVC for cable entry and protect the inside of the box.
Connect wire with copper conductor dropwire ø0.6 ø0.8 jacket to max. ø2.4, and network cable with copper conductor jacket ø0.4 to ø0.6 ø0.6 to ø1 (dimensions in mm).

ADVANTAGES:
The contact point is protected from the environment by a special compound and design supports a minimum of 100 operations without deterioration.
The contact side of the station and the subscriber side are one body, which ensures that there is always connection between the two points.
The subscriber side connection is highly secure because it has two contact points in each pair.
The contact module allows cutting and test the line without touching the connections, the system has been designed so that the connector module is operated with a single blade screwdriver.
The housing is resistant to UV rays.
Supports category 5 speed transmission
With discharges C/D Red Pin
Without discharges S/D Grey Pin
Dielectric rigidity 3000 V rms, 60 Hz c.a / 60 seg
ICONTEC Standard NTC 3605, 3608
diameter copper conductor network cable Ø0.4 to 0.6 mm isolation Ø 0.6 to Ø1.2 (AWG.26-22)
Crusade cable Ø0.6 to 0.8 mm isolation max Ø 3.5 (AWG.22-20)

Cotizar este producto

Ver Ubicación